axle bearings

[peter frankston]

i need to change my axle bearings and want to go with sealed. any body know what size they are?

[rustytortoise]

they are the size of your face.

[Lizzard-Poop]

they are the size of your face.

Jon, not nice!




They are the size of your ass.

[peter frankston]

good ones. now, tell me the size of the bearings damn it.

[Lizzard-Poop]

Lol, sorry I don't know that info.

[deluxemike]

do you have the old ones out?

i just took an old one to Miller Bearing and said, "i want this bearing in sealed"............ and they said, "o.k."

[peter frankston]

i did not pull them yet but i have a local miller bearing so that is what i will do. damn you for not knowing.

[rustytortoise]

good luck getting them out.

[crusty67t2]

good luck getting them out.

hahahahhahaha

[rustytortoise]

good luck getting them out.

hahahahhahaha

right?

[peter frankston]

i gots me a puller. should work, i hope.

[rustytortoise]

is it a axle bearing puller for a vw? i have had to cut grooves in the outer part of the bearing and chisel them out. or take the axle tube off.

[peter frankston]

nope, cheap pulley puller but the arms should fit into the bearing. i have not tried yet.

[crusty67t2]

the best way is to drive the axle in as far as it will go then pull it back out and hopefully the bearing comes out of the axle tube far enough to get a puller on it...
you may not need a puller if there not stuck..there a bitch if there stuck.

[rustytortoise]

i've never been able to push it in far enough to pull it out.

but i used this one puller once, and i'm pretty sure it broke my snap ring on the axle.

i <3 irs.

[peter frankston]

i hope by next show season to have my pan built. irs with shortened link pin frame head and flat floors that will not hang below the body.

[rustytortoise]

word!